For this decorative wall installation use adhesive to attach the panels to the wall.
System and method for installing wall covering panels.
Once you ve got the wallpaper off spray the walls with a gel stripper to help remove leftover paste.
The lipping joining to the mdf panel is clamp with industrial glue kept for dry at least two hours to strong enough joint.
15 1966 5 sheets sheet 2 i.
Fm mm m 42.
Apply more water as needed.
Soak the wallpaper with water using a sponge or floor mop.
Do not remove nails.
Use just enough cone head nails to secure the panels to the wall while the adhesive sets up.
Prepare temporary installation at the factory to make sure that panels are proper as per the sizes provided in the drawing.
After 15 minutes use a putty knife to scrape the wallpaper off the walls.
Once the adhesive becomes tacky press the panel into place and tap it with a hammer to secure the bond.
Assembly for installing prefabricated wall panels filed nov.
Prepare the mdf bracket male and female to hang the panels at the wall.
Before panel installation begins the wall structural support framing must be checked for straightness and alignment and must be checked to verify that the wall panels can be installed without interference.
Leave a millimeter space between each panel to allow for expansion and contraction as you stick them to the wall or frame.
15 1966 5 sheets sheet 5.
Then lightly nail the tops so that they stay in position and pull the bottoms out and set them on a block of wood.
Assembly for installing prefabricated wall panels filed nov.