Sturd I Floor Panels

Panel uses and information designed for use in single layer floor construction beneath carpet and pad.

Sturd i floor panels.

Glue nailing is recommended for sturd i floor panels though panels maybe nailed only. Dryply sturd i floor these plywood panels have a water repellent coating to provide weather protection during the normal exposed construction cycle. These panels feature a built in underlayment that allows the convenience of using only sturd i floor under certain finish flooring especially carpet and pad. This plywood is manufactured with 5 layers of veneer in alternating directions which increases strength and stiffness to minimizes floor bounce.

Apa rated sturd i floor provides smooth surface for application of carpet and pad. In general a panel intended for use as subfloor is designed as a structural member with a span rating such as 16 20 or 24 inches on center that is clearly marked on the grade stamp see illustration. Apa rated sturd i floor panels can be manufactured as conventional plywood as a composite or as oriented strand board. Stagger panel end joists.

However it is also suitable for use as subfloor roof and diaphragm sheathing. Sturd i floor rated panels are designed as combination subfloor and underlayment panels usually intended to go under a carpet and pad. Cd grade underlayment this product is 1 1 8 in thick 4 ft wide by 8 ft long and is made from southern pine. Sturd i floor also features apa quick fit tongue groove design so panels it together quickly and easily.

Georgia pacific drymax 3 4 x 4 x 8 sturd i floor tongue groove plywood subfloor at menards send cancel mail in rebate is in the form of merchandise credit check valid in store only. Spacing of 1 8ʺ is recommended at panel ends and edges. A for all flooring except the toughguard ii installation system armstrong flooring recommends an additional 1 4 or thicker layer of apa plywood underlayment. This single layer construction is a cost saving and time saving solution that works.

The span rating is stamped on each panel. Glue nailing is recommended for sturd i loor panels though panels maybe nailed only. Stagger panel end joists. Install with smooth side up.

Sturd i floor sturd i floor is a combination subfloor underlayment produced from osb or plywood. Touch sanded for uniform thickness. This product is also tongue groove. Structural use panels 4 0 trademark 2 0 the apa trademark description apa rated sturd i floor is primarily intended for combination subfloor underlayment single floor applications.

The span rating is stamped on each panel. Sturd i floor combines the strength of subfloor and underlayment into a single plywood panel.